Tesla Elec seamless kvm switch supplier for computer

1

Auto scan time interval settings

[MIN]: Press button [MIN] to loop between 0~59 minutes

[SEC]: Press button [SEC] to loop between 0~59 seconds

[Set]: After setting minutes and seconds, press button [Set] to enter final scan time interval setting

2

Status LED

Red: Normal status

Green: Auto scanning mode

4

IR receiver

Receive IR signal

3

LED display

Display current selected input source number

5

Keypad

[1~8]: Press these buttons to directly select input 1~8 sources.

[Close]: Press this button directly will turn on or turn off the HDMI output display

[Scan]: Press this button to start or stop automatically scan between input 1 to input 8. The interval time can be set by button [Set], [MIN], [SEC] as described bove

6

LAN

TCP/IP console interface

7

Power switch

Turn on or off the power supply

8

IR In

Connect IR receiver extension cable to this port, then it is

 able to use IR control even the KVM switch is installed in

a rack

9

DC 12V

12V DC power supply

10

RS232 port

Connect this port to any control termination, then it is able

 to select the input sources by sending RS232 commands

11

USB 2.0 port

For USB 2.0 devices, for example printers, USB hard disk, barcode scanner, touch pad etcl

12

HDMI output

Connect to HDMI display

13

USB keyboard and mouse input

For USB keyboard and mouse input, including wireless keyboard and mouse

14

HDMI input ports

Connect to HDMI sources devices

15

USB data

Connect to computer’s USB ports by USB type A to type B cable